Tag: Mesa Furnace Repair

 

Mesa Furnace Repair – Problems that People Have and How to Solve Them

Fuel furnaces use propane or natural gas to heat the areas inside them. About the fact that gas is often referred to as a costly source of heat, gas furnaces typically burn cleaner than oil furnaces and hence need less repairs. However, when issues arise with gas furnaces, they are usually simple to find and fix. The following are four typical issues with older gas furnaces, as well as what you may expect from repairs. Mesa Plumbers has some nice tips on this.
There is no heat generated by a furnace. If your gas furnace isn’t producing heat, it may be due to one of the following issues: a closed control panel, a tripped fuse or cable, a faulty thermostat, or a non-functioning pilot light. While you might be able to resolve certain problems on your own, if you are unfamiliar with gas furnaces, it is safest to contact a gas furnace repair company (i.e. a heating and cooling firm). Regardless of which of the above issues the furnace is experiencing, it should be fixed the next day by an HVAC repair specialist, and neither of the aforementioned issues should result in significant repair costs.
A furnace produces insufficient heat. It’s possible that the occlusion of the blower, loosening of the blower cord, or a dirty filter or flame are causing your furnace to produce less fuel. Such questions would often occur around the same time. A furnace that generates insufficient heat as a result of one of the above issues will normally be fixed at a low cost on the same day as a furnace that produces no heat. If a gas furnace repair specialist suspects that the trouble is caused by one of the above issues, and that any of the other issues are likely to occur, save time and get them all repaired with one visit.
A Furnace Is Always Switching
On/Off switch Either of the following issues is likely to happen if the furnace switches on and off before reaching the necessary heat output: a jammed blower, a dirty filter, or an unusually dry motor. In the first scenario, a technician will clean your blower and its surroundings with a vacuum; in the second scenario, the technician will uninstall or clean the temporary air filter and replace it with the permanent air filter; and in the third scenario, the technician will lubricate the engine by injecting oil into the necessary oil ports. The expense of the service should be low in each case.
The Pilot Light on a Furnace Won’t Switch On
Many furnaces have a tiny blue flame emerging from a small pipe so you will see if the pilot light is on by dropping to the floor and looking at the underside of the furnace. If the pilot light is on, you’ll see a small blue flame coming from a small pipe. A clogged pilot pane, insufficient gas supply due to an improperly placed gas valve, or a faulty thermocouple are the most common causes of a pilot light that won’t light. In any case, the approach requires only light labour and can be completed at a low cost.